NEWS CENTER

Home / News / Industry News / Tooth surface defects ---Vibration

Tooth surface defects ---Vibration

Update:18 Dec 2017
Summary:

The reason: Due to vibration   1) a large transmission […]

The reason:
Due to vibration
  1) a large transmission gap within the machine
  2) workpiece and hob clamping rigidity is not enough
  3) the choice of cutting capacity is too large
  4) After the bracket is installed, the gap is large
Countermeasures:
Find and eliminate sources of vibration
  1) for the use of a long time and serious wear and tear on the machine overhaul
  2) improve the clamping rigidity of the hob, for example, to narrow the distance between the support; Shank hob should try to use a large shaft diameter. For example, as far as possible to increase the supporting end surface, the supporting end surface (including the workpiece) is only allowed to be concave; the distance between the upper and lower ejecting pins is shortened
  3) Correct choice of cutting
  4) Correctly install the rear bracket

http://www.iks-sh.com/